MULTIQ 219 DRIVER

Check that the video input from the Graphics card falls within the timing range listed in the table of section 6 of the Monitor. Please connect all cables to the back of the monitor before mount the VESA metal to it. Check that Video Signal Cable from the Monitor has been securely and correctly connected. To unlock, do the same procedure again. Hot air may cause damage to the cabinet and other parts. Shielded interconnected cables and shield power cords must be employed with this equipment to insure compliance with the pertinent RFD emission limits governing this device. It’s a community-based project which helps to repair anything.

Uploader: Doule
Date Added: 25 March 2015
File Size: 66.85 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 40365
Price: Free* [*Free Regsitration Required]

If still not clear, apply a small amount of non-ammonia, non-alcohol based glass cleaner onto a clean, soft, line-free cloth, and wipe then screen. TTL Level, ohms Sync.

MQ219 Touch Signage Monitor

Only support to video function monitor 6. Operation is subject to the following two conditions: Removal of the monitor cover may expose you mulgiq dangerous voltage or other risks. No user serviceable parts inside. Hot air may cause damage to the cabinet and other parts. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measure: Only support to DVI-D, function monitor.

  ACER TRAVELMATE 5720 VIDEO DRIVER

You may use the standard resolution SXGA x 60 as the monitor type. Video Input Pin Assignment The Picture will auto-adjust by itself.

There is no need to change the hardware of your computer, just plug and play. Do not put on unstable position. Do not spray with liquid or aerosol cleaners. This procedure only has to be done once and the monitor will remember its optimal settings in the future.

Please consult section 7 for OSD screen adjustment procedures. Problem No image on monitor screen? Make sure your graphics adapter has the following settings: The female receptacle of the cord set must meet IEC requirements and may look like Figure A1 below: The first line always shows the current selected or active menu item. When no operation is done for around 60 seconds default OSD timeoutit goes back to the stand-by mode and no more switching is accepted except [MENU] to restart the setting.

English, Germany, French, or Swedish are available. Colours of image on screen are abnormal Disturbances on Screen Troubleshooting Tip 1.

This is selecting the applicable input source: A slider with current value is displayed. Do not block ventilation slots and openings with objects or install the monitor 29 a place where ventilation may be hindered. Unpacking After you unpack your LCD Monitor, please make sure that the following items are included in the carton and in good condition.

  INTERSIL 3886 DRIVER

These two merits make it easy to use in almost any environment and easy to transport. Pressing it again will turn it off.

Changes or modifications not expressly approved by the manufacturer could void the user authority to operate the equipment. This chapter will guide you through the correct installation 129 of your LCD monitor. The graphics card must also be set up correctly in Windows and make sure the video output of the graphics card is listed in Section 6.

MultiQ Power supply MQ, PSU – EET Europarts IE

This removes dust and other particles. Just mount four screws to the monitor that indicate as right picture.

Check that the video input from the Graphics card falls within the timing range listed in the table of section 6 of the Monitor. There are three items: