If forced to master mode, the device can either disconnect or downshift to a Mbps link. Only the primary adapter receives incoming traffic. Deleting virtual teams directly in Windows Device Manager can cause severe consequences. Caution Some multi-port devices can be forced to master mode. The load is balanced according to the lowest common denominator of adapter capabilities, and the bandwidth of the channel. Performance options – Receive Descriptors or Receive buffers Sets the number of buffers used by the driver when copying data to the protocol memory.
|Date Added:||18 March 2016|
|File Size:||56.46 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Show all Show less. Safari Chrome IE Firefox. Sets the number of buffers used by the driver when copying data to the protocol memory. A ‘failed’ primary adapter passes its MAC and Layer 3 address to the failover secondary adapter.
Intel® Ethernet Adapter Drivers for MS-DOS*
The Software is copyrighted and protected by the laws of the United States and other countries and international treaty provisions. Contractor or Manufacturer is Intel. The browser version you are using is not recommended for this site.
Specifically, Intel grants no express or implied right to you under Intel patents, copyrights, trademarks, or other intellectual property rights. With RLB, all traffic other than IP traffic, is passed on the primary adapter, regardless of its speed. If forced to master mode, the device can either disconnect or downshift to a Mbps link. All bindings are restored when the LBFO team is removed.
Your personal information will be used to respond to this inquiry only. Intel is not obligated under any other agreements unless they are in writing and signed by an authorized representative of Nddis2. Teaming features include failover protection, increased bandwidth throughput aggregation, and balancing of traffic among team members. Our goal is to make Download Center a valuable resource for you. Automatically set to On or Off depending on speed and adapter type when the intle is installed.
Performance options – Transmit Descriptors or Transmit buffers. Can be used with any switch.
Except as expressly provided herein, no license or right is granted to you directly or by implication, inducement, estoppel, or otherwise. Set the activation delay on the advanced tab of team properties. Usage considerations Enable Jumbo frames only if devices across the network support them and are configured to use the jntel frame size.
Downloads for Intel® Gigabit Ethernet Controller
Only two adapters can be assigned to an SFT team. Any other use of the Software, including but not limited to use with non-Intel component products, 882567lm-3 not licensed hereunder.
Changing the setting can improve link quality with certain link partners. They are not intended as high-performance drivers.
Only the primary adapter receives incoming traffic. If the system is used more heavily, consider tuning both the base adapter and the virtual adapter settings for either RX or TX traffic. Driver does not wait for Auto Negotiation On: Title to all copies of the Software remains with Intel. You may only distribute the Software to your customers pursuant to a written license agreement. I accept the terms in the license agreement. The browser version you are using is not recommended for this site.
Teaming options are supported for Windows versions where the following Intel adapters receive full software support:. If large packets make up the majority of traffic and more latency can be tolerated, Jumbo frames can reduce CPU utilization and improve wire efficiency. At greater link speeds, more interrupts are created, and CPU rates also increase. Gigabit master slave mode Decides whether the adapter or link partner is designated as the master.